I tightened all the easy to reach clamps and then my thermostat housing clamp started leaking about 9k miles later. It is still under warranty so I let the dealer repair the leak. Said it was a pain to access (had to remove the tank) and took several turns to tighten the clamp.
First 40 mile service.
Cheers mates, about to do the 40 mile service a lot of other Norden owners need to do: tightening hose clamps to stop coolant from leaking. Has anyone compiled a good guide on where each hose clamp is? Some are really easy to find and access but I've seen some chatter about needing to remove the fuel tank to access some. Thanks.
1 - 2 of 2 Posts
1 - 2 of 2 Posts
Husqvarna Norden Forum
We’re the largest Husqvarna Norden community and owner's club - join the conversation about the Husqvarna Norden 250, 401, 501, 701 & 901
Full Forum Listing
Recommended Communities
